DLA 13008 Guide for Conformal Coated Tantalum Capacitors 4

The metric dimensions shall prevail. The dimensions in inches are circular and for reference only. （1）A0，B0，K0， Determine from the maximum size to the end of the terminal extending from the component body and/or body. The size of the component. The gap and cavity (A0, B0, K0) between the end and side of the terminal or component body must be within a minimum of 0.002 inches (0.05 millimeters) and a maximum of 0.020 inches (0.50 millimeters). The allowed gap must also prevent the components from rotating within the cavity by no more than 20 degrees.diode

(2) The tape with components should be wrapped around the radius "R" without damage. The minimum trailer length may require additional length to provide the "R" minimum value, for a 12 mm embossed strip on a reel with a hub diameter close to the N minimum value.

(3) This size refers to the flat area cavity or cavity edge where the carrier tape deforms outward from the edge of the sprocket hole to the embossing, whichever is smaller.diode

(4) The size refers to the adhesive tape between the embossing chamber or the edge of the chamber, from the edge of the conveyor belt opposite the sprocket hole to the flat area where the conveyor belt deforms outward, whichever is smaller. (5) The position of the embossed hole should be measured from the sprocket hole that controls the embossed position. The size embossing positions should be independent of each other.diode

(6) The size of B1 is only a reference size for the gap of the tape feeder.diode

P=power loss (W),+25 ° C, as shown in the table in the product data sheet (Power dissipation). RESR=frequency specified for equivalent series resistance of capacitors Z=impedance frequency of capacitors 2.1 The sum of peak AC voltage and applied DC voltage shall not exceed the voltage of the capacitor. 2.2 When the negative peak AC voltage plus the applied DC voltage does not allow the voltage to reverse beyond 10% of the DC operating voltage+25 ° C.diode