Conformal Coating Guide for Conformal Coated Tantalum Capacitors 5

(4) This size refers to the tape between the flat area where the bracket deforms outward from the edge of the bracket tape opposite the sprocket hole, or the edge of the cavity, whichever is smaller.diode

(5) The position of the embossing hole should be measured from the sprocket hole that controls the embossing position. The size embossing positions should be independent of each other.

(6) The B1 size is only a reference size - conveyor gap.diode

Application Guide

1. AC Ripple Current: The maximum allowable ripple current should be determined according to the following formula: QQ image 20191225104507.pngdiode

P=power loss (W),+25 ° C, as shown in the table in the product data sheet (Power dissipation). RESR=frequency specified for equivalent series resistance of capacitors

2. AC Ripple Voltage: The maximum allowable ripple voltage should be determined according to the following formula: QQ image 20191225104520. png or, according to the formula: QQ image 20191225104534. pngdiode

P=power loss (W),+25 ° C, as shown in the table in the product data sheet (Power dissipation). RESR=frequency specified for equivalent series resistance of capacitors Z=impedance frequency of capacitorsdiode